On saving smart walls with doors inserted into the Symbol directory, then right mouse click to preview in O2C, there is no preview as the walls have been changed to zb=0/zh=0.
Also, Some doors that were cut into a wall prior to saving as a symbol, are now shown with walls extending through them as though they have not been cut into the wall.
Also, Some doors that were cut into a wall prior to saving as a symbol, are now shown with walls extending through them as though they have not been cut into the wall.
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com