To all,
I must have dreamt this but I thought we had a command to turn off "empty layers".
I use go-to-views & in general a standard layer list from project to project, this over time has increased in the number of layers. On the start of a new project I usually have all empty layers off & then start forming new go to views as the project plans evolve.
However for some reason on this new project I didn't have all the empty layers off when I was about to save my first go to view, so I thought.......I know, I'll click on that "empty layers off" button,....
O.k. it looks like we don't have one of these, so just wondered if anyone else thinks this would be a good addition to DataCAD...
Over & out,
Clayton.
Ps. I've also been meaning to ask, where does Dave A Giessleman get those cool moving avatars from on this forum..???
I must have dreamt this but I thought we had a command to turn off "empty layers".
I use go-to-views & in general a standard layer list from project to project, this over time has increased in the number of layers. On the start of a new project I usually have all empty layers off & then start forming new go to views as the project plans evolve.
However for some reason on this new project I didn't have all the empty layers off when I was about to save my first go to view, so I thought.......I know, I'll click on that "empty layers off" button,....
O.k. it looks like we don't have one of these, so just wondered if anyone else thinks this would be a good addition to DataCAD...
Over & out,
Clayton.
Ps. I've also been meaning to ask, where does Dave A Giessleman get those cool moving avatars from on this forum..???
Trotman & Taylor Architectural Consultants U.K.