Just switched to windows 7 and on Datacad 12. May not be a Windows problem but didn't have this before.
When I hatch it won't display the hatch until I right click out of the command. I'm certain I didn't have to do this before. Is there a setting for this ?
I can see it creates the boundary and I can hatch all over the place, but until I exit (right click) I see nothing.
Thanks,
Dave
When I hatch it won't display the hatch until I right click out of the command. I'm certain I didn't have to do this before. Is there a setting for this ?
I can see it creates the boundary and I can hatch all over the place, but until I exit (right click) I see nothing.
Thanks,
Dave