Is there anyway to control "layer" within symbols? That would be a sweet little feature for sure if it isn't possible. Not a big fan of exploding tons of symbols to get entities to be turned on or off.
Thanks.
Kent
Thanks.
Kent
Roger D wrote:If you can not control it by utilizing scales, and maybe placing them on the drawing sheet using MSP layouts, maybe you could utilaze Attributes linked to a database, and one of the entries in the the database could be a "blank" place holder that then does not have any other entries for that one one setting, so you sizes would not show????
Users browsing this forum: No registered users and 29 guests