I just brought in a previously drawn wall section detail from the symbol browser (I had saved said detail as a symbol - will be a time-saver). Anyway, I did my changes for this specific project, and then did a hatch pattern of earth @ 100 scale around the footing, a hatch pattern of earth @ 50 scale in the backfill area, and then a hatch pattern of concrete @ 50 scale inside the monolithic slab area. Then I copied it over to the right to detail another iteration with an awning extension, and all the hatch just.... disappeared. I tried esc. to regenerate. No good. I tired closing down DataCad and reopening. No good. I am loath to redraw the hatches because I suspect they are still there, but I have no way to test if they are or not.
Any ideas?
Any ideas?