Every thing working fine, all of a sudden I get O2C failed to create. Any ideas?
Do you get the message in other drawings? In a new default drawing create a few new 3D primitive entities like a cone, cube, does it still do it?
Thanks! - Josh
Do. Or do not. There is no try.
Josh's Digital Downloads is come back online soon. Stay tuned. (soon is a relative term)
Do. Or do not. There is no try.
Josh's Digital Downloads is come back online soon. Stay tuned. (soon is a relative term)
I sometimes (rarely) get this happen. Closing and restarting DataCAD seems to fix it. You can also try using File/Purge on the drawing if it persists.
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Who is online
Users browsing this forum: No registered users and 7 guests